Skip to content

DC Audio Pitbull 20.0K Amplifier 20,000W

Sale
Original price $4,799.99
Current price $3,199.99

Description

The Pitbull 20k competition series amplifier is a 20,000 watt mono block. It is built for 12 volt audio systems. It will not operate on 16 or 18 volt systems. It’s built with the best of the Best parts from the Mosfets to the Large Tiffany Jacks.

It comes with a bass knob and a clipping indicator. For power inputs it will accept triple 0 awg for power and triple 0 awg for ground.

Key Features

• 1 ohm stable

• Variable low pass filter

• Variable subsonic filter

• Variable bass boost

• Wired remote control

• Triple 0 awg power and ground inputs

We recommend for installation

• 1 upgraded battery under the hood

• 3 extra 800ci battery in the rear

• Minimum of two 0 awg ran from the front battery to the rear battery

• All 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 6 runs into the amp

• 2 Upgraded aftermarket alternators

• Dash mounted voltage meter

Features Voltage 10.0kw
Output Power (RMS) 4 ohm 14.4V 3,000Wx1
4 ohm 14.4V 7500x1
2 ohm 14.4V 13,000x1
1 ohm 14.4 20,000x1
Input Sensitivity 6V~0.2V
Low Pass Filter Switchable
( @ 24 dB Slope) Variable Hz 35~250
Subsonic Filter Switchable
( @ 24 dB Slope) Variable Hz 10~50
Bass Boost Variable dB 0-9dB
Frequency Response Hz 15-270
Signal to Noise Ratio dB 85
Damping factor 300<
Efficiency @ 4ohm % Over 90%
THD @ 4ohms Less than 0.1%
Fuse Rating 2,000 Amps
Indicator Power Yes
Protection Yes
Clip Yes
Speaker & Power terminal Mold Type Yes
Power Gauge 0Ga x 3
Heatsink Length 37.75" (940mm)
Heatsink Length 11.5" (292mm)
Heatsink Length 2.6" (66mm)